class WIZNET5K – control WIZnet5x00 Ethernet modules

This class allows you to control WIZnet5x00 Ethernet adaptors based on the W5200 and W5500 chipsets. The particular chipset that is supported by the firmware is selected at compile-time via the MICROPY_PY_WIZNET5K option.


import network
nic = network.WIZNET5K(pyb.SPI(1), pyb.Pin.board.X5, pyb.Pin.board.X4)
# now use socket as usual

For this example to work the WIZnet5x00 module must have the following connections:

  • MOSI connected to X8

  • MISO connected to X7

  • SCLK connected to X6

  • nSS connected to X5

  • nRESET connected to X4

It is possible to use other SPI buses and other pins for nSS and nRESET.


class network. WIZNET5K ( spi , pin_cs , pin_rst )

Create a WIZNET5K driver object, initialise the WIZnet5x00 module using the given SPI bus and pins, and return the WIZNET5K object.

Arguments are:

  • spi SPI object which is the SPI bus that the WIZnet5x00 is connected to (the MOSI, MISO and SCLK pins).

  • pin_cs Pin object which is connected to the WIZnet5x00 nSS pin.

  • pin_rst Pin object which is connected to the WIZnet5x00 nRESET pin.

All of these objects will be initialised by the driver, so there is no need to initialise them yourself. For example, you can use:

nic = network.WIZNET5K(pyb.SPI(1), pyb.Pin.board.X5, pyb.Pin.board.X4)


WIZNET5K. isconnected ( )

返回 True if the physical Ethernet link is connected and up. Returns False 否则。

WIZNET5K. ifconfig ( [ (ip , subnet , gateway , dns) ] )

Get/set IP address, subnet mask, gateway and DNS.

When called with no arguments, this method returns a 4-tuple with the above information.

To set the above values, pass a 4-tuple with the required information. For example:

nic.ifconfig(('', '', '', ''))
WIZNET5K. regs ( )

Dump the WIZnet5x00 registers. Useful for debugging.